cLAN3524-XF / cLAN3524-MQ
Hardware features
- Ethernet port: RJ45 10/100 Mbit
- Serial ports: 2 (Both are RS232 and RS485)
- Digital Inputs : 16 voltage activated (8 of them can count pulses of up to 1 Khz)
- Analog Inputs: 8 configurable as 0-1V / 0-10V / 4-20mA
- Digital Outputs: 8 open collector type
- Power supply requirements: 10 to 30 Vdc
- Dimensions: 85 x 60 x 105 mm (Height x Width x Length)
- Operation Temperature: -15°C a +65ºC
Data Acquisition
- Physical inputs/outputs
- Modbus inputs/outputs (embedded Modbus master)
- Embedded Modbus slave
- Other protocols using script programming
Operating modes:
- XF model : Monitoring by WEB page / Database (Ethernet datalogger)
- MQ model : MQTT client
- Monitoring from SCADA
- Remote access to serial port
- Telemetry Controller
- Local I/O control (using the script programming feature)
- Direct connection with SCADA using its Modbus RTU and Modbus TCP slaves
Server link :
- Ethernet (Local network or using the Internet)
- Satellital (with external satellite modem, XF model only)
Wiring
Wiring – Power supply
Wiring – RS232 port – RS485 port
The RS232 port is of the 5-wire DTE type (TX, RX, RTS, CTS, GND) and has a terminal board for its connections.
The RS485 port is of the 2-wire type (TR+ and TR-) and has a terminal board for its connections.
There's no need to configure whether you are going to use the port RS232 or RS485. Just connect the wires to the corresponding terminals.
We now indicate the terminal board for the connection of inputs and outputs of the cLAN.
In this model it is not necessary to open the cLAN con switch between current and voltage inputs.
2020-09-28
